Raimondi Leveling System Starter Kit (RLS)
search
  • Raimondi Leveling System Starter Kit (RLS)

Raimondi Levelling System Starter Kit (RLS)

$149.95
GST excl. ($164.95 GST incl.)

Raimondi Leveling System Starter Kit (RLS)

An essential kit for professional tilers. This kit ensures you have leveled, perfectly set tiles, and with ease.. it also quickens up the tile installation process. Learn exactly how to use this leveling system below.
TFSCRLEVKITLSK
New product
Available instore or CALL 1300 KEVMOR
  • All Products in Stock in Australia
  • Free Shipping for online orders over $100 Aust wide*

Leveling System Starter Kit - Raimondi RLS

Raimondi Levelling System Starter Kit is a must for tiling professionals.

*Includes:

  • 1 x RAI-LSATPF - Traction Floor Pliers

  • 1 x RAI-LSBC100 - 100 x Base Clips

  • 1 x RAI-LSW100 - 100 Wedges

For proper setting, correct leveling of tiles is required.

It's not easy to set tiles that flex and are thin. Heavy and large tiles also pose problems due to floor foundations that are not even.

Because of this, even though the tiles looked perfect and level during installation, after the adhesive sets, often times there is a different appearance of levels that change the "perfectness" of your tile floor installation soon after.

The Raimondi Levelling Starter Kit helps solve this issue.

Leveling spacers help avoid this mess. They work by keeping the perfect level of tiles just installed. Not only that, but leveling spacers also make the adhesives set faster.

So you get FASTER setting & ensured PERFECT levelled tiles.

Clip Types (2 Versions):

  • 3mm - 12mm thick tiles (1/8” - 1/2”)

  • Large Clips for 12mm - 20mm thick tiles (1/2” - 3/4”). 

  • Wedge used on the two clips just as easily. The wdge will list you a lifetime...

Makes it easy: Position the leveling spacers and remove them just as quick & easy... 

How To Use The Leveling System Starter Kit

Setting The Support:

  1. After adhesive is spread, place the support under the tiles, along each of its four tile sides.

  2. It will depend on the tile size, but you'll want to set 1 or more supports on each of the tile sides

  3. Get tile set and then use a rubber mallet to beat it.

Inserting The Wedge:

  1. Make sure not to pass the breakpoint - at this step, you need to place the wedge into the slot for support.

  2. Recommendation: the special traction-adjustable-pliers will make this much easier and are recommended.

Removing The Support:
After the adhesive sets, separate the protruding part of the support to remove it. This separates the base from the support and is necessary for removing it. Again, the traction-adjustable-pliers, then a rubber mallet (if no mallet, your feet can also get the job done). Make sure you beat parallel to joint.